Playa Orb Repair Checklist
From OrbSWARM
Revision as of 13:23, 19 August 2007 by 206.15.64.18 (Talk)
Out in the desert, it will be difficult to run to Fry's if we blow a fuse. So lets take everything we'll need for every possible scenario.
One idea is for every system to be responsible for emergency repairs to their system. However if we can consolidate a checklist of things we'll need before we get there, we can reduce duplicates of materials we haul out there, and we can make sure we don't overlook anything.
Support
- Extension cords and power strips
- Worklights
- Work table, surface, tarp
- Shade
- Magnets (to keep nuts and bolts off the playa)
Tools
- Welder
- Soldering iron
- Multimeter
- Scope?
Spare Parts
- Motors
- SPU
- Motor Controller
- H-Bridge
- Daughter Board
- Shell
- shell bolts and nuts
- Ribs
- Axle
- Chain
Power System
- Batteries
- relays
- male and female molex connectors
- extra fakeys
- quick disconnects
- crimping tool for quick disconnects
- crimping tool for molex
- lots of 14 gauge wire
- Chargers
Consumables
- Solder
- Heat Shrink
- Wire
- Screws
- Fuses
- Connectors
- Batteries (Lots of AAs for remote controls)
- Tape (masking, duct, electrical)
- Stuff to clean dust
